ST 20-3/8

Cylinder for table mounting

Properties

  • for use with the flanged mounting adapter AF1
  • offers 3/8" thread for mounting stands that terminate on such a thread, such as RS 420 L5U
  • Diameter 20 mm

Description

This cylindrical mounting adapter is inserted into the AF 1 elastic suspension. Its 3/8" tap screw can hold a support rod or gooseneck.The adapter exists in a long and a short version.

There are two notches in the sides of the adapter, through which the cable or cables can be passed. Alternatively, the cable can be passed through the centre of the adapter. For this purpose, the adapter has a hole drilled in the center of its top which can be used to pass a miniature cable through. However, the connector has to be dismantled to do this. The...

This cylindrical mounting adapter is inserted into the AF 1 elastic suspension. Its 3/8" tap screw can hold a support rod or gooseneck.The adapter exists in a long and a short version.

There are two notches in the sides of the adapter, through which the cable or cables can be passed. Alternatively, the cable can be passed through the centre of the adapter. For this purpose, the adapter has a hole drilled in the center of its top which can be used to pass a miniature cable through. However, the connector has to be dismantled to do this. The only exception is the RC KC cable, since its connector at the amplifier end does not fit through the 20 mm opening.

moreless

Practice

A typical set with built-in tripod looks like this:

  • AF 1 - table flange
  • ST 20-3/8 - mounting cylinder
  • S 250 L5U - gooseneck
  • CCM 4 - microphone

For longer tubes / goosenecks the following setup is possible:

  • 2 * AF 1 - table flange
  • ST 20-3/8 - mounting cylinder
  • RS 420 L5U  - gooseneck
  • CCM 4 - microphone

A solution with RL is realized as follows:

  • 2 * AF 1 - table flange
  • ST 20-3/8 - mounting cylinder
  • STR 250 - support rod
  • RL 350 - stand tube
  • RG 8 - stand swivel
  • CCM 4 - microphone

Variants & Options

There is a short version and a long version.

#165007: ST 20-3 / 8:
This short version is suitable for mounting in a table flange AF 1 for tubes and goosenecks up to 300 mm in length

#165009: ST 20-3 / 8 ext:
This long version is suitable for mounting in two table flanges AF 1 for tubes and goosenecks over 300 mm in length, see chart under "Application"